Categories

Link ECU G5 Voodoo Pro Engine Management

Link ECU G5 Voodoo Pro Engine Management

$4,865.73
(No reviews yet) Write a Review
SKU:
152-5000
Shipping:
Free Shipping

Description

G5 Voodoo Pro puts real magic in your hands and opens a new world of possibilities with the ability to control port plus direct injection, more injector and ignition drives, advanced communications and many more features.

 

  • Control any engine with 2 cylinders, all the way up to 12 cylinders, thanks to:
    • 12 injector pins
    • 8 ignition pins
    • 4 injector/ignition dual role pins
  • Access up to 30 auxilary pins (when setup for a 4-cylinder sequential engine):Any unused injector/ignition pins can be used as an auxiliary pin
    • 8 dedicated auxiliary pins
    • 4 shared e-throttle/H-Bridge pins
    • 2 shared wideband heater pins
    • Up to 16 from spare injector and ignition drives
  • All ignition and auxiliary pins are back feed protected.
  • 14 analog inputs
  • 10 digital inputs
  • 4 temperature inputs
  • Dual knock inputs
  • 2 trigger inputs
  • Dedicated ignition switch pin
  • 2 x internal wideband lambda controllers
  • Dual e-throttle, with internal solid state throttle disconnect relays
  • 5v sensor supply
  • CAN 1 input now supported via CAN connector

 

Communications

  • USB-C (cable included)
  • Connect directly to the ECU via built-in Wifi Access Point, or add it to an existing network (Antenna Included)
  • Dual CAN (CAN 1 on CAN connector, CAN 2 on header E)
  • GPS (antenna included)

 

Size & Weight

  • Length: 177.1mm (6.97 inches)
  • Width: 137.3mm (5.40 inches)
  • Min side height: 15.5mm (0.61 inches)
  • Max side height: 40.2mm (1.58 inches)
  • Weight: 795g (28 ounces)

 

Connectivity

The G5 Voodoo Pro supports the following comms standards:

  • USB-C
  • Wi-Fi
  • CAN
  • GPS

 

It is now possible to connect to your ECU using a standard USB-C cable, or alternatively by using WiFi.

You can now access CANBUS 2 via its own dedicated pins in Header E freeing up two Digital Inputs.

GPS connectivity can be initialised by simply adding a GPS antenna.

 

Requires “A”, “B” & “E” connector kits (not supplied).