Description
MaxxECU - GEN2 SPORT With Connector Kit.
Modern engine control, built into a compact, affordable package.
The MaxxECU GEN2 SPORT brings next-generation engine management to builds that don’t need a full-size ECU. It runs on the proven GEN2 platform and is tuned through MaxxECU’s easy-to-use MTune software.
The MAP sensor, wideband controller, knock inputs and data logging are all built in, so you skip a lot of extra boxes and wiring.
Why You’ll Want It
- Sequential control of up to 6 cylinders (12 cylinders in wasted spark)
- Built-in 550 kPa MAP sensor supports up to 4.5 bar / 65 PSI of boost
- Built-in wideband controller works with LSU 4.2, 4.9 and 5.2 sensors
- Dual knock sensor inputs for engine protection
- 4 GB onboard logging, over 2000 channels at up to 1000 Hz
- Wi-Fi, Bluetooth and USB-C for wireless tuning and fast PC connection
- IP68-rated aluminium enclosure, sealed against water and dust
Inputs & Outputs
- 4 pulse inputs (VR/Hall) with selectable pull-ups
- 12 analog inputs with selectable pull-ups
- 6 injector outputs (high/low impedance, peak and hold)
- 6 ignition/GP outputs (selectable 5V/12V/GND)
- 7 general-purpose ground outputs
- 2 H-bridge outputs with E-Throttle support
- CAN bus for vehicle communication, expansion and transmission control
Connectivity & Software
- Wi-Fi communication with MTune
- Bluetooth connectivity with MDash
- High-speed USB-C (480 Mbit/s) for PC communication
- Additional USB-C (12 Mbit/s) for tablet communication and charging
- MTune PC software for configuration, tuning and logging
- Built-in 3-axis accelerometer (up to 8G)
