Categories

K-Series to BMW Transmission Adapter Plate V1.1 + Flywheel + Release Bearing

K-Series to BMW Transmission Adapter Plate V1.1 + Flywheel + Release Bearing

€1 400,67
(No reviews yet) Write a Review
SKU:
KSTAF
Shipping:
Calculated at Checkout

Description

V1.1K to ZF billet aluminum transmission adapter with a billet aluminum flywheel.
In the past our kits used another brand's steel adapter plates, however with certain fitment issues we designed our own plates using 6061 aluminum.
Our V1.1 adapter plate is designed by 3D scan then measured again for a precise fit.  Our adapter plate also allows you to run both 5spd and 6spd ZF trans and the Getrag G260 trans from the BMW E30.
The V1.1 adapter is also K20 friendly, and we have made some changes for anyone running heater core hoses behind the engine.
Comes with genuine SACHS release bearing customized to fit the 5spd ZF Flywheel.  The 6spd ZF flywheel will use the release bearing that is included with whichever clutch kit you purchase.
The adapter plate will allow you to run BMW ZF 5spd, ZF 6spd, and the G260 transmission (E30) to a Honda K-series engine.
Transmission can be sourced from inline 6 engine 3-Series (E46), inline 6 engine 3-Series (E36), inline 6 engine Z3, and certain E60 5-Series with the ZF 6spd.
Made in USA.

 

***IF YOU PLAN ON RUNNING A SINGLE DISK CLUTCH WITH OUR K-SWAP FLYWHEEL, YOU WILL HAVE TO USE A CLUTCH WE HAVE LISTED ON OUR WEBSITE, UNDER THE "K-SWAP KIT" CATEGORY"***

 

 

***Off road use only***