TF Steel Parts

Touge Factory

TF 300ZX Z31 Inner and Outer Tie Rod Set - V.2 with Aurora Bearings

Our Z31 outer tie rods will correct and reduce bumpsteer on lowered cars due to lower arm geometry.The outer tie rod design with the taller shank relocates the pivot point, which also reduces binding and leading to premature failure.The version 2...

Touge Factory

TF CEL O2 Sensor Adapter Heat Sink Wide Band Bung Extender

TF Heat Sink O2 Sensor adapter is a multi purpose tool! You can use this to eliminate the annoying CEL on your gauge cluster due to high flow cats or test pipes. Another use for this is to space out your O2 sensor on your wideband from direct contact...

Touge Factory

TF Evo 8/9 Brembo Brake Caliper Adapter for Nissan S13/S14

TF★ Evo 8/9 Brembo Brake Caliper Adapter is stainless steel for anti-corrosion properties.  Comes with all hardware for complete installation.  This is for the Front of Nissan 240SX S13/S14/S15.  This kit uses Evo 8/9 rotors.  Evo 8/9...

Touge Factory

TF Extended 50mm Wheel Studs Subaru STI (12x1.25)

50mm Extended wheel studs for Subaru and Saab. Studs are made out of high quality heat treated steel.  Thread pitch:  12x1.25 * *Sold individually*

Touge Factory

TF Extended Wheel Studs Nissan S13 S14: 50mm 13mm Knurl (12x1.25)

You are looking at 50mm Extended wheel studs.  Made for today's high performance cars with thick centered racing wheels or if you're running spacers Made out of Heat-Treated steel. These are for the FRONT and REAR hubs on the S13 (1989 - 93 240sx)...

Touge Factory

TF Extended Wheel Studs Nissan S14 & 300ZX: 50mm 14mm Knurl (12x1.25)

You are looking at 50mm Extended wheel studs.  Made for today's high performance cars with thick centered racing wheels or if you're running spacers Made out of Heat-Treated steel. These are for the FRONT hubs on the S14 and the Z32. These are long...

Touge Factory

TF High Pressure Power Steering Line - Nissan 240SX S13 S14 SR20DET

If you notice a reddish puddle under the car, you are probably going through what most 240sx owners will all go through.Leaky power steering lines.On a old S-chassis, it is not uncommon to find the high pressure steering line to go bad.  Whether it...

Touge Factory

TF Works Stainless Steel Logo

TF Works Stainless Steel Logo 2mm thick, 6inches wide. Can be used as an emblem, or welded onto other components.

Touge Factory

TF★ Super Short 90° CEL Fix O2 Sensor Adapter 304 Stainless Steel

This is for anyone running a high flow catalytic converter or a test pipe in place of the restrictive stock cat. If you replaced yours already, then you probably have an annoying CEL on your gauge cluster. Our Short CEL fix is angled 90°  for...